Description

Commodity list:

30ml = 30ml electrolytic cell + matched three electrodes + inlet valve + outlet valve. Other specifications in the option have the same meaning.

The default matching three electrodes are: silver chloride electrode + platinum sheet electrode (platinum sheet size: length 10mm * width 10mm * thickness 0.1mm, electrode rod diameter 6mm) + electrode clamp (sample sheet thickness cannot exceed 3mm). If the silver chloride electrode is replaced, you can leave a message in the order remarks and replace the silver chloride electrode with the required electrode name. For example, the order remark information: replace the silver chloride electrode with calomel electrode, and then the three electrodes we send will become: calomel electrode + platinum sheet electrode + electrode clamp: if you change the silver chloride electrode into mercuric oxide electrode or mercurous sulfate electrode, please perform the same operation, please leave a message on the order or contact the customer service personnel.

1. Tank material: high borosilicate glass.

2. The electrolytic cell is an advanced sealed electrolytic cell system, which is commonly used in three electrode system.The volume of the tank ranges from 10ml to 500ml, which can also be customized according to requirements.

3. The electrode part of the electrolytic cell realizes the internal connection of the electrode through the earphone jack on the cover.The three electrode system achieves advanced sealing.

4. The electrode of the electrolytic cell must be matched with the cell body.

5. No sand core salt bridge or Lujin capillary can be added to the electrolytic cell, and only silver chloride can be used Silver electrode.

6. The electrolytic cell realizes atmosphere protection by adding valves and gas devices, which is connected with the aeration device.The connected valve is in the air inlet direction.

7. The electrolytic cell is an advanced sealing system, which can be vacuumized through valves (less than 100KPA) or pressurized, and the bottom of the electrolytic cell shall be made into a round bottom shape Meanwhile, for the sake of safety, the pressure shall not be greater than 0.6MPa.

8. Material of electrolytic cell cover: polytetrafluoroethylene. The cover is different according to the volume of electrolytic cell.The size of the inner screw cover is basically divided into 50mm，60mm，70mm.